Problem – Interface with microprocessor and write an assembly Subtract content of two ports by interfacing with microprocessor. The interfacing happens with the ports of the Microprocessor. The main IC’s which are to be interfaced with are: 1. PPI. 2. PIC. 3. USART. PPI: 82C55 The 82C55 is a popular interfacing component, that can interface any TTL-compatible I/O device to the microprocessor.
|Published (Last):||28 June 2005|
|PDF File Size:||17.62 Mb|
|ePub File Size:||12.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
Send data on port B to glow Y3 and Y4. The peripheral devices includes. Select your Language English. Return to main program. It can be driven by digital signal. Dont use any Interrupts.
A stepper motor is a digital motor. Stepper Motor Control Program: Load control word in CR. Your email address will not be published. Reset out signal from clock generator is connected to the Reset signal of the While executing an instruction, there is a necessity for the microprocessor to access memory frequently for reading various instruction codes and data stored in the memory.
The electric bulbs are controlled by relays. Get the Excite wiht. So it is necessary that we interface keyboard and displays with the microprocessor.
These devices are nothing but a combination of many devices on a single chip.
Send data on port A to glow Y1 and Y2. We know that keyboard and Displays are used as communication channel with 8805 world.
Address lines A 0 — A 1 are used by for internal decoding. It functions as an input device if it is connected to buffer and as an output device if it is connected to latch. The register values are chosen in Fig. Assume address of the control word register of as 23H. In this type of interfacing we use latches and buffers for interfacing the wiyh and displays with the microprocessor. Types of Interrupts.
Intel A Programmable Peripheral Interface
Find display RAM command word. Only lower data bus D 0 — D 7 is used as is 8-bit device.
Assume address of the control word register of as 83H. Motor shown intsrfacing the circuit has two phases, with center-tap winding. Input Output Interfacing Techniques. Looking forward for your comments and suggestions There are two types of interfacing in context of the processor. Initialize in read FIFO. Load mask pattern to enable RST 7. The transistors are selected such that they can source rated current for the windings. So we are using a keyboard and monitor as Inteerfacing and output along with the processor.
Find program clock command word. If not zero, repeat.
Memory mapped I/O interfacing with 8085 microprocessor
Initializeport A and port B. Get the 7 segment code. Output with handshake 2.
Interface wth x 4 matrix keyboard and 4 digit 7-segment display and write an tssembly language program to read keycode of the pressed key and display same key on: So there is chance of faults and defects.